Thursday, March 30, 2017

A couple of mold boxes


I had a bit of spare time this past weekend so I made up mold boxes for the ECW casualties and the lamppost.


The bottom box with the lamppost will be used vertically, so I made the lantern end slightly broader than the top so it'll stand up better during the pouring process. The photo shows half a dozen deep dents made in the Sculpey in which the lamppost master is embedded. These are so the two halves will match up perfectly and prevent slipping when in use. That bulge emerging from the brown base will eventually form the funnel-shaped pouring hole.

The next stage will be to pour the silicone. Once set I'll carefully remove it, flip it over, and build another box around it. With two-part molds, it's essential to coat the surface of the first part with Vaseline before pouring the next batch of silicone. Without it the silicone will stick to the previous layer and be impossible to separate.

While I was at it I sculpted a couple of gutter pieces both for gaming use and for diorama-style bookends. These will be molded too and match up with the cobblestone pieces I made earlier. The small square piece on the metal plate at the top is the corner for the gutter and is ready for baking. I need to trim and sand some areas of these pieces for a better fit.


I think I've now made all the pieces needed for a good mold-making session, so once the weather warms up a bit I'll have at it.

For those who may be interested, Bruce Hirst of Hirst Arts is currently designing small brick molds which will be extremely useful for buildings and sewer/dungeon systems. I suspect I'll be sending an order for them one of these days.


1 comment:

Michael Awdry said...

Best of luck when it comes to the pour, very interested to see the results.

 

home page uniques
Fishing Rods