Tuesday, December 14, 2010

Someone's rockin' my steamboat - 2

On to the next stage, assembling the paddle wheel. The Roi des Belges and other steamboats of this era often had large rectangular paddle-boxes over the stern wheels, which simplifies things from a modelling perspective. Everything within the box doesn't have to be constructed; only the pertinent parts that show.

The picture below shows the deckhouses in place and the start of the paddle wheel assembly. I took a thick card spool that once held carton sealing tape, cut a half inch piece from it then divided it into two half-inch segments. Two short lengths of wooden strip form the main spokes with a length of dowel between them as the axle.

The whole was glued between the two lengths of basswood projecting from the main deck. Note the upward bias of the wheel segments to the stern.

Short lengths of wood strip made the paddles themselves. I used a strong impact adhesive to glue these in place.

The shot below shows the general effect, with District Commissioner Carstairs providing a sense of scale.

Tomorrow should see me onto the next stage - constructing the paddle box and the upper deck.

1 comment:

Bluebear Jeff said...

Nice clear instructions, AJ. Thanks.


-- Jeff

 

home page uniques