Friday, February 10, 2017

Movement trays - 1


Moving 15mm figures en-masse can be a bit of a chore, so I decided to make a few movement trays for my Dux Britanniarum figures. These will be for the levy.

The basics are simple enough - a sandwich of liquid nails adhesive between two layers of stiff card, followed by more liquid nails on the top to create the shallow pits in which the figure bases fit.

First up, I marked out the circular areas where the figures will go by using a one cent piece. The bases are slightly smaller than the penny so I'll have a little space to play with. These movement bases are for the levy, which I assume will lack the ordered discipline of regular troops, so I made the placement of the circles a bit irregular to reflect their more relaxed formation.

Next, I smeared liquid nails around the circular marks without being too fussy about overspill. The main idea is to create areas in which the figures will sit and not slide off easily. 


I followed this up with a good dose of fine sand. The adhesive is nice and sticky so it retains a grip on the sand, and it sets hard without undue warping. 


The adhesive takes a few hours to set, but since I'm not in any hurry this isn't a problem. Once it's all dry/set, I'll paint it and apply a bit of dried tea in patches to represent rough foliage.


2 comments:

Michael Awdry said...

These should certainly do the job.

A J said...

I hope so, Michael. I'm still noodling with the idea but it seems to be shaping up well.

 

home page uniques